F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Solenoid Valve Body
REMOVAL:
WARNING:BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES. WASH
HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING
WATER FOR 15 MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY, DRINK
WATER AND INDUCE VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
CAUTION:Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION:Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
-
Remove the Rear Anti-lock Brake System (RABS) valve.
1
Disconnect the RABS valve electrical connector.
2
Remove the two hydraulic lines and plug them.
3
Remove the two RABS valve nuts.
4
Remove the RABS valve.
INSTALLATION:
-
To install, reverse removal procedure.
^
Bleed the brakes. See: Brake Bleeding/Service and Repair/Rear Anti-Lock Brake System (RABS) Bleeding
