F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
ASSEMBLY:
CAUTION:Never reuse piston seals and dust boots.
NOTE: Never reuse brake fluid that has been drained from the hydraulic system or has been allowed to stand in an open container for an extended
period of time.
Front Disc Brake Caliper Pistons, Seals And Dust Boots
-
Lubricate the piston boot, caliper piston, piston seal, and cylinder bores with High Performance DOT3 Brake Fluid C6AZ-19542-AB or DOT 3
equivalent meeting Ford specification ESA-M6C25-A.
-
Install caliper pistons.
1
Install the piston seal.
2
Install the piston boot.
3
Insert the caliper piston.
CAUTION:Be careful not to damage or dislodge the piston seal.
4
Press the caliper piston into the cylinder bore being careful not to cock the caliper piston.
-
Install the front disc brake caliper; refer to Brake Caliper Removal and Installation. See:
-
Bleed the system, refer to the Hydraulic System Service And Repair for bleeding procedures.
