F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
Master Cylinder Reservoir And Filler Cap
- Fill the (A) brake master cylinder reservoir and install the (B) brake master cylinder filler cap.
Rear Anti-Lock Brake System (RABS) Bleeding
WARNING:BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES. WASH
HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING
WATER FOR 15 MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY; DRINK
WATER AND INDUCE VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
CAUTION:Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION:Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
NOTE: When any part of the hydraulic system has been disconnected for repair or replacement, air may get in to the system and cause spongy brake
pedal action. This requires the bleeding of the affected portions of the hydraulic system after it has been properly connected. The hydraulic
system can be bled manually or with pressure bleeding equipment Brake Bleeder.
-
Connect a clear waste line to the LH front disc brake caliper bleeder screw and submerge the free end of the tube in a container partially filled with
clean brake fluid.
-
Open the bleeder screw and cycle the brake pedal until no more air is seen at the waste line.
