F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
52.
Disconnect heater return hose from coolant tube, then remove heater hose from vehicle. Refer to Figure 30.
53.
Remove retainers securing routing bracket to rear of right-hand cylinder head, then remove routing bracket and ground strap. Refer to Figure 30.
54.
Remove coolant tube retainers securing coolant tube to rear of right hand cylinder head, then remove coolant tube. See Figure 30.
55.
Remove jack handle from radiator air deflector.
56.
Remove air deflector on top of radiator.
57.
Disconnect coolant recovery hose from radiator.
58.
Using Fan Clutch Holding Tool T84T-6312-C and Fan Clutch Wrench T93T-6312-B, remove cooling fan and clutch assembly.
59.
Remove cooling fan shroud.
60.
On automatic transmission models, disconnect transmission lines from radiator.
61.
Disconnect lower radiator hose from radiator.
62.
Remove radiator support brackets, then the radiator.
63.
Remove water pump pulley, then the water pump.
64.
On 4.6L and 5.4L Windsor engines, proceed as follows:
