F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
Clutch Master Cylinder: Service and Repair
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash it immediately with
water.
NOTE: When replacing the clutch master cylinder, remove the tubing from the vehicle for the bench bleeding procedure See: Clutch Fluid/Service and
Repair.
REMOVAL
1. Disconnect the clutch master cylinder push rod from the clutch and brake pedal pivot shaft lever.
2. Remove the Clutch Pedal Position (CPP) switch.
3. Remove the clutch cylinder reservoir.
(1) Remove the bolts.
(2) Remove the clutch cylinder reservoir.
4. Raise and support the vehicle.
WARNING: THE ELECTRICAL POWER SUPPLY TO THE AIR SUSPENSION SYSTEM MUST BE SHUT OFF PRIOR TO
HOISTING, JACKING OR TOWING AN AIR SUSPENSION VEHICLE. THIS CAN BE ACCOMPLISHED BY TURNING OFF THE
AIR SUSPENSION SWITCH LOCATED IN THE REAR JACK STORAGE AREA. FAILURE TO DO SO MAY RESULT IN
UNEXPECTED INFLATION OR DEFLATION OF THE AIR SPRINGS WHICH MAY RESULT IN SHIFTING OF THE VEHICLE
DURING THESE OPERATIONS.
