F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
Transmission Position Switch/Sensor: Adjustments
NOTE: Use Digital Transmission Range (DTR) Sensor Alignment Tool to align both TR and DTR sensors.
1. Raise and support vehicle.
WARNING: THE ELECTRICAL POWER TO THE AIR SUSPENSION SYSTEM MUST BE SHUT OFF PRIOR TO HOISTING,
JACKING OR TOWING AN AIR SUSPENSION VEHICLE. THIS CAN BE ACCOMPLISHED BY TURNING OFF THE AIR
SUSPENSION SWITCH LOCATED IN THE RH KICK PANEL AREA. FAILURE TO DO SO MAY RESULT IN UNEXPECTED
INFLATION OR DEFLATION OF THE AIR SPRINGS WHICH MAY RESULT IN SHIFTING OF THE VEHICLE DURING THESE
OPERATIONS.
2. Disconnect the manual lever shift control cable.
3. Disconnect the TR or DTR electrical connector.
4. Remove the manual control lever.
(1) Remove the nut.
(2) Remove the lever.
CAUTION: Discard outer manual control lever shaft nut. Do not reuse.
5. Loosen the TR or DTR bolts.
6. Use DTR sensor alignment tool, to align the DTR or TR sensor slots.
NOTE: Manual shift lever must be in the neutral position.
