ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Recall - Fuel Line Inspection|Page 6203 > < Recall - Fuel Line Inspection|Page 6201
Page 9
background image

8.

Use a 3/8 inch extension to check for 10 mm (3/8 inch) clearance between the fuel lines and the shift lever. See Figure 7.

^

If the clearance is 10 mm or greater, go to the next step.

^

If less than 10 mm clearance is observed, gently push up on the rear retaining bracket using only your hand to obtain adequate clearance while
maintaining at least 10 mm (3/8 inch) clearance from the top of the lines to the underbody. See Figure 8.

^

If you are unable to obtain the 10 mm (3/8 inch) clearance between the fuel lines and the shift linkage, or between the fuel lines and the
underbody, call the Recall Hotline at 1-800-325-5621.

9.

Release the vehicle only if ALL the following conditions are met:

^

All clearances meet specification (10 mm minimum).

^

There are no signs of damage to either front or rear fuel line near the fuel filter.

Recall - Fuel Line Inspection|Page 6203 > < Recall - Fuel Line Inspection|Page 6201