F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
11. Install the two transmission mount nuts.
12. Install the VSS.
(1) Install the VSS.
(2) Install the bolt.
(3) Connect the electrical connector.
13. Install the rear driveshaft.
(1) Position the rear driveshaft.
(2) Install the four bolts.
14. Fill (A) transmission with fluid until it reaches the bottom of the (B) fill port and install the (C) case plug.
-
Use Motorcraft MERCON Multi-Purpose Automatic Transmission Fluid XT-2-QDX or DDX or equivalent Mercon Automatic Transmission
Fluid. MERCON(R) automatic Transmission Fluid is being replaced by MERCON(R) V as a service fluid, as per TSB 06-14-4.
15. Lower the vehicle.
