F 150 2WD Pickup V8-4.6L CNG SOHC VIN 9 (1997)
Input Shaft: Service and Repair
DISASSEMBLY
1. Inspect the input shaft bearing.
2.Remove and discard the front bearing oil scoop ring.
3. Use (A) Bearing Cone Remover and an (B) arbor press to remove the (C) bearing.
CAUTION:
-
Use of essential tools may cause damage to the bearings being removed.
-
Hold the input shaft so it does not fall.
NOTE: Only remove the bearing if replacement is necessary.
ASSEMBLY
1. Use (A) Bearing Cone Replacer, (B) Bearing Cone Remover, and an arbor press to install the (C) bearing.
