F 150 2WD Pickup V8-4.6L SOHC VIN W (1998)
2. Install the rear brake shoes and linings.
1
Position the rear brake shoes and linings.
2
Install the brake shoe hold-down spring pins and the brake shoe hold-down springs.
3
Install the brake shoe anchor pin guide plate.
3. Assemble the brake adjuster screw assembly.
1
Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or an equivalent silicone compound
meeting Ford specification ESE-M1C171-A.
2
Install the brake adjuster screw into the brake shoe adjusting screw nut to the end of the threads, and then loosen one-half turn.
3
Install the brake shoe adjusting screw socket on the brake shoe adjusting screw nut.
NOTE: To prevent incorrect installation, the socket end of each brake adjuster screw is stamped R or L.
4. Install the brake adjuster screw assembly.
1
Position the brake adjuster screw assembly.
2
Install the brake shoe adjusting screw spring.
3
Position the brake shoe adjusting lever cable.
4
Install the cable guide.
5
Position the adjusting lever return spring and the brake shoe adjusting lever.
6
Hook the brake shoe adjusting lever cable to the brake shoe adjusting lever.
