F 150 2WD Pickup V8-4.6L SOHC VIN W (1998)
NOTE: Make sure that safety belt webbing is not twisted prior to installation.
NOTE: The orientation of the SuperCab rear retractor and driver retractor anchors is with the vertical leg in the outboard direction.
NOTE: Make sure that after an Automatic Locking Retraction (ALR) retractor is replaced that the retractor is not in the ALR mode of operation
when it is installed
60/40 Split Bench Seat and Bench Seat, Front Center Passenger
T55 "Torx Plus" Bit
Special Tool(s)
REMOVAL
1. Remove the front passenger safety belt.
1. Use T55 "Torx Plus" Bit to remove the bolt.
2. Feed the belt up through the seat cushion strap and remove the front passenger safety belt tongue assembly
INSTALLATION
1. To install, reverse the removal procedure.
^
Check the restraint system for proper operation.
NOTE: Make sure the tongue webbing is outside the seat side shield, not under the shield. The webbing could be cut if it is routed under the seat
side shield.
