F 150 2WD Pickup V8-4.6L VIN W (2006)
Seat Track: Service and Repair
Seat Track - Manual
SEAT TRACK - MANUAL
Removal and Installation
WARNING:
-
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the seat and depower the SRS.
2. Remove the front seat backrest.
Regular cab and SuperCab seats
3. NOTE: Passenger seat shown, driver seat similar.
Remove the 6 front seat frame rear support bolts and the support.
-
When installing, install the bolts and torque in the sequence shown.
-
To install, tighten to 30 Nm (22 lb-ft).
Driver seat
4. Remove the 2 seat track position sensor bracket nuts and sensor.
All seats
5. NOTE: Driver seat without seat integrated restraints (SIR) shown, others similar.
