ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Sensors and Switches - Body and Frame > < Seat Track - Power|Page 8668
Page 3
background image

12. Prove out the supplemental restraint system (SRS) as follows:

Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately 6 seconds and then turn OFF. If an air bag supplemental
restraint system (SRS) fault is present, the air bag indicator will:
-

fail to light.

-

remain lit continuously.

-

flash.

The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered must be diagnosed and
repaired.

Clear all continuous DTCs from the restraints control module using a diagnostic tool.

Sensors and Switches - Body and Frame > < Seat Track - Power|Page 8668