F 150 2WD Pickup V8-4.6L VIN W (2006)
CAUTION: When disconnecting the brake lines, do not allow brake fluid to drip onto the ABS module or premature failure may occur.
CAUTION: Do not allow brake fluid to drip into the ABS module electrical connector cavity or premature failure may occur.
1. Disconnect the battery ground cable.
2. Remove the air cleaner assembly.
3. NOTE: The brake lines must be installed in the same location as removed.
Remove the 4 brake line-to-HCU fittings.
^
To install, tighten to 17 Nm (13 ft. lbs.).
4. Remove the 2 HCU-to-bracket nuts and the HCU.
^
To install, tighten to 9 Nm (80 inch lbs.).
5. Remove the ABS module.
6. NOTE: The HCU bracket does not have to be removed in order to complete this procedure.
If necessary, remove the 3 HCU-bracket-to-frame bolts and the bracket.
^
To install, tighten to 30 Nm (22 ft. lbs.).
7. To install, reverse the removal procedure.
^
Bleed the brake system.
