F 150 2WD Pickup V8-4.6L VIN W (2006)
Oil Pick Up/Strainer: Service and Repair
Oil Pump Screen and Pickup Tube
Material
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the oil pan.
3. Remove the 3 bolts and the oil pump screen and pickup tube.
^
Discard the O-ring seal.
Installation
1. CAUTION: Make sure the O-ring is in place and not damaged. A missing or damaged O-ring can cause foam in the lubrication system, low oil
pressure and severe engine damage.
NOTE: Install a new O-ring and lubricate with clean engine oil.
Install the oil pump screen and pickup tube and the 3 bolts.
1. Tighten to 25 Nm (18 ft. lbs.).
2. Tighten to 10 Nm (89 inch lbs.).
2. Install the oil pan.