F 150 2WD Pickup V8-4.6L VIN W (2006)
2. Tighten the bolts in the sequence shown to 10 Nm (89 inch lbs.).
3. Install the 2 rear oil pan bolts.
^
Tighten to 20 Nm (15 ft. lbs.).
4. NOTE: Lubricate the crankshaft rear seal with engine oil before installation.
Using the special tools, install a new crankshaft rear seal.
5. NOTE: Lubricate the crankshaft oil slinger with clean engine oil before installation.
Using the special tools, install a new crankshaft oil Slinger.
6. Install the engine rear cover plate.
7. Install the flexplate and the 6 bolts. Tighten the bolts in 2 stages in the sequence shown.
