F 150 2WD Pickup V8-4.6L VIN W (2006)
15. Using the special tool, install a new O-ring seal on the pressure line fitting.
16. Connect the power steering pressure tube.
^
Tighten to 65 Nm (48 ft. lbs.).
17. Position the power steering pressure tube support bracket and install the nut.
^
Tighten to 10 Nm (89 inch lbs.).
18. CAUTION: If the pulley has been removed and installed twice, install a new power steering pump pulley.
Using the special tool, install the power steering pump pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, install a new pulley. If there is 1 paint mark or none
at all, use a pencil to mark the web area of the pulley near the hub.
19. Install the accessory drive belt idler pulley and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
