F 150 2WD Pickup V8-4.6L VIN W (2006)
4. If the evaporator core orifice is intact, engage the special tool. Hold the T-handle stationary while rotating the tool body to remove the evaporator
core orifice.
5. If the evaporator core orifice is broken, screw the end of the special tool into the broken orifice. Hold the T-handle stationary while rotating the
tool body to remove the evaporator core orifice.
Installation
1. Lubricate the evaporator core orifice O-rings in clean PAG oil and install the evaporator core orifice using the special tool.
2. Connect the evaporator core orifice access fitting.
-
Install a new O-ring seal.
3. Lubricate the refrigerant system with the correct amount of clean PAG oil.
4. Evacuate, leak test and charge the refrigerant system.
