F 150 2WD Pickup V8-4.6L VIN W (2006)
4. Disconnect the EGR system module vacuum connector.
5. Disconnect the exhaust manifold-to-EGR system module tube from the EGR system module.
6. Remove the bolt, the stud bolt, the EGR system module and the gasket. Discard the gasket.
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of the old gasket.
Clean the EGR system module gasket mating surfaces.
2. Install a new gasket with the raised circle facing the throttle body adapter.
3. Position the EGR system module and install the bolt and stud bolt.
-
Tighten to 25 Nm (18 lb-ft).
4. Connect the exhaust manifold-to-EGR system module tube the EGR system module.
-
Tighten to 40 Nm (30 lb-ft).
5. Connect the EGR system module vacuum connector.
6. Connect the EGR system module electrical connector.
7. Position the brake booster vacuum hose bracket, install the nut and connect the brake booster vacuum hose.
-
Tighten to 10 Nm (89 lb-in).
8. Connect the battery ground cable.
