F 150 2WD Pickup V8-4.6L VIN W (2006)
1. Inspect and clean both coupling ends. Install new O-ring seals and garter springs if necessary.
-
Lubricate the O-ring seals with clean engine oil.
2. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
tube.
Fit the male fitting into the female end and push until the garter spring snaps over the flared end of the female fitting.
3. Make sure the coupling is engaged by pulling on the lines.
4. Install the safety clip.
Disconnect - Type II