F 150 2WD Pickup V8-4.6L VIN W (2006)
Engine Ignition - RH
Exploded View
Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the ignition coil electrical connector.
3. Remove the ignition coil retaining bolt.
-
To install, tighten to 10 Nm (89 lb-in).
4. Rotate the ignition coil clockwise 30-40 degrees to clear the fuel injection supply manifold. Use a twisting motion while pulling up on the ignition
coil and remove.
5. NOTE: Verify that the ignition coil spring is correctly located inside the ignition coil boot and that there is no damage to the tip of the boot.
To install, reverse the removal procedure.
-
Apply dielectric compound to the inside of the coil boots before installing.
