F 150 2WD Pickup V8-4.6L VIN W (2006)
7. NOTE: If equipped with manual lumbar, make sure this wire harness is routed above the manual lumbar cable.
Connect the safety belt buckle pretensioner and safety belt buckle switch electrical connectors and attach the wire harness retainer to the seat track.
8. On vehicles with SIR seats, connect the BTS electrical connector.
-
Route the wire harness, connect the electrical connector and attach the J-clip.
9. If equipped, connect the lumbar cable.
-
Route the cable and attach the J-clip.
10. Install the passenger seat into the vehicle and repower the system. Do not prove out the supplemental restraint system at this time.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
Verify the safety belt retractor operates without excessive effort or binding.
11. WARNING: Do not separate components.
CAUTION:
-
Make sure the seat is completely assembled before rezeroing.
-
The following precautions must be taken before rezeroing the OCS system:
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the OCS system is not at a temperature below 0°C (32°F) or above 45°C (113°F) when initiating the rezeroing process.
If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within
the limits, 0°C to 45°C (32°F to 113°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before rezeroing and nothing is placed on the seat during the rezeroing
process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the rezeroing process.
NOTE:
-
For best results in rezeroing, the OCS system should be at or near room temperature, 10°C to 29°C (50°F to 85°F).
-
If the first attempt to rezero the OCS system is unsuccessful, a second attempt must be made.
Rezero the occupant classification sensor.
-
With the front passenger seat empty, use a diagnostic tool to trigger the active command and rezero the occupant classification sensor.
12. NOTE: The ignition switch must be cycled after rezeroing the OCS system.
Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately 6 seconds and then turn off. If an air bag supplemental restraint
