F 150 2WD Pickup V8-4.6L VIN W (2006)
4. NOTE:
-
The inboard and outboard head restraint sleeves are not interchangeable.
-
If necessary, install new head restraint sleeves.
Access and push the release tabs and pull the 2 head restraint sleeves out of the backrest frame tubes.
5. Detach the 2 safety belt tower screw covers.
6. Remove the 4 screws and the safety belt tower.
7. Lift the material and release the J-clip.
8. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the
seat backrest foam pad.
Separate the hook and loop fasteners and remove the hog rings on the front of the backrest foam pad.
9. Remove the hog rings on the back of the backrest foam pad and remove the backrest trim cover.
10. Remove the backrest foam pad from the backrest frame.
11. Remove the safety belt retractor bolt and the safety belt retractor.
