F 150 2WD Pickup V8-4.6L VIN W (2006)
6. Position the shift cable bracket and install the 2 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
Vehicles equipped with 4.2L engine
7. Install the shift cable bracket.
1. Install the bolt.
^
Tighten to 40 Nm (30 ft. lbs.).
2. Install the nut.
^
Tighten to 25 Nm (18 ft. lbs.).
8. Rotate the manual lever forward until the travel stops. Then rotate the manual lever back 2 detents to the (D) position.
9. Connect the shift cable to the shift cable bracket. Do not connect the shift cable to the manual control lever at this time.
10. Connect the shift cable to the shift cable bracket and lock the adjuster.
11. Verify the vehicle will start in PARK and NEUTRAL. Verify the reverse lamps illuminate in the REVERSE position. If not, check the adjustment
