F 150 2WD Pickup V8-5.4L Prop SOHC VIN Z (1998)
52.
Install water pump pulley. Tighten retainers in sequence shown in Figure 68, to 20-30 Nm (15-22 lb-ft).
53.
Install radiator. Make sure radiator is sitting on mounting insulators.
54.
Install radiator supports. Tighten retainers to 25-35 Nm (18-26 lb-ft).
55.
Connect lower radiator hose to radiator.
56.
On automatic transmission models, connect transmission cooler lines to radiator. Tighten lines to 16-24 Nm (12-18 lb-ft).
57.
Install cooling fan shroud. Tighten retainer 108-10 Nm (71-89 lb-in).
58.
Using Fan Clutch Holding Tool T84T-6312-C and Fan Clutch Wrench T93T-6312-B, install cooling fan and clutch assembly.
59.
Connect coolant recovery hose to radiator.
60.
Install air deflector on top of radiator.
61.
Install jack handle on radiator air deflector.
62.
Using clean coolant, lubricate coolant tube O-ring seal. Install coolant tube. Tighten retainers on rear of right cylinder head to 40-55 Nm (29-40
lb-ft).
NOTE:
Make sure left side fuel charge harness is between routing bracket and cylinder head.
63.
Install routing bracket and ground strap to rear of right cylinder head. Tighten retainers to 9-12 Nm (80-107 lb-in).
64.
Install heater return hose to coolant tube.
65.
Install cam cover gaskets on both cam covers.
NOTE:
The cam cover must be installed within four (4) minutes after applying silicone.
66.
Apply Silicone Gasket and Sealant F6AZ-1 9562-AA or equivalent, to the two (2) places where the engine front cover meets the cylinder head.
