F 150 2WD Pickup V8-5.4L Prop SOHC VIN Z (1998)
Hydraulic Hose: Service and Repair
Special Tools
REMOVAL
1. Raise and support the vehicle.
WARNING: THE ELECTRICAL POWER SUPPLY TO THE AIR SUSPENSION SYSTEM MUST BE SHUT OFF PRIOR TO
HOISTING, JACKING OR TOWING AN AIR SUSPENSION VEHICLE. THIS CAN BE ACCOMPLISHED BY TURNING OFF THE
AIR SUSPENSION SWITCH LOCATED IN THE RH KICK PANEL AREA. FAILURE TO DO SO MAY RESULT IN UNEXPECTED
INFLATION OR DEFLATION OF THE AIR SPRINGS WHICH MAY RESULT IN SHIFTING OF THE VEHICLE DURING THESE
OPERATIONS.
2. Disconnect the line from the plastic clip at the floor flange.
3. Uncouple the lower end of the line from the clutch slave cylinder using (A) Clutch Coupling Tool.
4. Lower the vehicle.
5. Remove the clutch master cylinder and line assembly.
6. Remove and discard the roll pin holding the line to the clutch master cylinder.
7. Disconnect the line from the clutch master cylinder by applying a slight tug on the line.
NOTE: Check that the 0-ring is still in the outlet port of the clutch master cylinder. If not, replace it.
INSTALLATION
1. Insert the new line into the clutch master cylinder outlet port.
