F 150 2WD Pickup V8-5.4L Prop SOHC VIN Z (1998)
2. Install the driveshaft flange yoke.
1
Start a new bearing cup into the driveshaft flange yoke.
2
Position the driveshaft flange yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup below the yoke surface.
^
Repeat for the other bearing cup.
3. Remove the driveshaft from the U-Joint Tool, and install the four snap rings.
NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U -joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
4. Check the U-joints for freedom of movement.
^
If binding, strike the yoke with a brass or plastic hammer.
NOTE: Do not strike the bearings.
5. Install the driveshaft.
