F 150 2WD Pickup V8-5.4L SOHC SC VIN 3 (2003)
1. For in-vehicle priming, disconnect the brake lines.
2. For bench priming, mount the brake master cylinder in a vise.
3. Install short brake tubes with the ends submerged in the brake master cylinder reservoir, and fill the brake master cylinder reservoir with High
Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent DOT 3 fluid meeting Ford specification ESA-M6C25-A. If DOT 3 is not
available use DOT 4 Brake Fluid meeting Ford specification SAE-J1704-DOT 4.
4. Have an assistant pump the brake pedal, or slowly depress the primary piston until clear fluid flows from both brake tubes, without air bubbles.
5. If the brake master cylinder has been primed at the bench, install it in the vehicle.
6. Remove the short brake tubes, and install the brake outlet tubes.
7. Bleed each brake tube at the brake master cylinder as follows
1. Have an assistant pump the brake pedal, and then hold firm pressure on the brake pedal
2. Loosen the rear most brake tube fittings until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal
tighten the brake tube fitting
