ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Vehicle Lifting|Description and Operation|Page 2508 > < Wheel Fastener|Front|Page 2504
Page 1
background image

Vehicle Lifting: Description and Operation

JACKING

WARNING:
-

The electrical power to the air suspension system must be shut down prior to hoisting, jacking or towing an air suspension vehicle.
This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so may result in
unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.

-

Do not run the engine when jacking the vehicle. The wheels contacting the ground could cause the vehicle to move.

-

Support the vehicle prior to performing any procedure requiring the vehicle to be jacked off the ground.

-

Make sure the jack and jack stands are properly located to prevent the vehicle from falling.

-

Wheel chocks should be used to prevent the vehicle from rolling and falling off the jack.

CAUTION:  Never use a halfshaft as a lifting point.

Jacking Points - Front, 4x4

Jacking Points - Front, 4x4

The jacking point is a raised boss located on the front suspension lower arm.

Jacking Points - Front, 4x2

Jacking Points - Front, 4x2

The jacking point is a flat portion on the frame indicated by the arrow cut out. The jacking point is located behind the front tire and wheel
assembly.

Jacking Points - Rear

Vehicle Lifting|Description and Operation|Page 2508 > < Wheel Fastener|Front|Page 2504