F 150 2WD Pickup V8-5.4L SOHC SC VIN 3 (2003)
2. Fill clutch master cylinder reservoir to full line.
^
Use Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford specification
ESA-M6C25-A.
3. Place clutch slave cylinder end of tube in a waste container.
4. NOTE: Make sure the clutch master cylinder reservoir is full during bleeding procedure to prevent air from entering the clutch master cylinder.
NOTE: Bleed the clutch master cylinder until a solid stream of brake fluid exits at the quick connect coupling end of tube.
Open the internal mechanism of the male quick connect coupling and fully depress and hold the clutch master cylinder push rod.
5. Release the (A) internal mechanism of the quick end connector and release the (B) clutch master cylinder push rod.
6. Install the clutch master cylinder.
^
Rotate the clutch master cylinder 45 degrees counterclockwise.
