ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Console - Storage Bin Detaches|Page 9862 > < Console - Storage Bin Detaches|Page 9856
Page 1
background image

Console: All Technical Service Bulletins
Console - Storage Bin Detaches

Article No.
99-8-12

05/03/99

INTERIOR - STORAGE BIN INSIDE CONSOLE

DETACHES FROM BOX - SUPER CAB VEHICLES
BUILT THROUGH 4/1/1999

LIGHT TRUCK:
1999 F-150, F-250 LD

ISSUE
The storage bin inside the console may fall dawn inside the console base on some vehicles. This may be caused by the box warping and not fitting
properly on the lip of the base.

ACTION
Drill a hole and add two (2) rubber bumpers for spacers. The spacers will increase the surface contact area and reduce the possibility of the bin falling.
Refer to the following Service Procedure for details.

SERVICE PROCEDURE

1.

Drill two (2) 3 mm (1/8") diameter holes through the upper left side wall approximately 25 mm (1") from each end (figure 1).

2.

insert two (2) small, conical head Bumpers - (N805844-S) into the drilled holes from the outside.

3.

Cut off the bumper tails on the inside of the bin.

PART NUMBER

PART NAME

N8O5844-S

Bumper

OTHER APPLICABLE ARTICLES: NONE 

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION

DESCRIPTION

TIME

Console - Storage Bin Detaches|Page 9862 > < Console - Storage Bin Detaches|Page 9856