F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
Thermostat: Testing and Inspection
Electrical Thermostat Test
CAUTION: Always vent the exhaust to the outside when performing this test.
NOTE: The electrical thermostat test is most accurate if performed indoors at less than 37.8°C (100°F) ambient air. This test may be performed with
or without the hood open and with the engine warm or cold.
1. Check the engine coolant level. Fill as needed.
2. With the key OFF, remove the Engine Coolant Temperature (ECT) sensor harness connector and attach ECT Sensor "T" Cable as a jumper
between the Powertrain Control Module (PCM) and the ECT Sensor. Attach 73 Digital Multimeter to the ECT Sensor "T" Cable. Voltage values
(0 to 5 V) may now be monitored while the sensor retains its connection to the wiring harness.
New Generation Star (NGS) Tester or the Service Bay Diagnostic System (SBDS) may be used to monitor the ECT on vehicles equipped with
Data Link Connector (DLC). The SBDS sequence to use for the screen is: Tool box-Electronic Engine Control and DCL-Item.
3. NOTE: Running this test with the vehicle in gear or with the A/C compressor clutch engaged (running) will cause improper diagnosis.
Place transmission in PARK (P) or NEUTRAL (N).
4. Start the engine and allow to idle throughout this test. Allow the engine to run for 2 minutes, then record the ECT voltage. Record the ECT
voltage every 60 seconds. When the ECT voltage trend changes direction or only changes slightly (0.03 volts or less) from the previous reading,
record this as the thermostat opening voltage. Use the voltage and corresponding coolant temperature chart.
5. If the thermostat opening voltage is greater than 0.75 volts and less than 82°C (180°F), install a new water thermostat.
6. If the thermostat opening voltage is less than 0.75 volts and greater than 82°C (180°F), the water thermostat is good and should not be replaced.
