F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
13. Using the special tool, remove the crankshaft pulley.
Installation
1. Note: The crankshaft pulley must be installed within four minutes after applying the silicone.
Apply silicone to the Woodruff key slot on the crankshaft pulley.
-
Use Silicone Gasket and Sealant F7AZ-19554-EA or equivalent meeting Ford specification WSE-M4G323-A4.
2. Using the special tool, install the crankshaft pulley.
3. Install the bolt and washer. Tighten the bolt in four stages.
-
Stage 1: Tighten to 90 Nm (66 ft. lbs.).
-
Stage 2: Loosen the bolt.
-
Stage 3: Tighten to 47 - 53 Nm (34 - 39 ft. lbs.).
-
Stage 4: Tighten an additional 85-90 degrees.