F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
4. Remove the ignition switch lock cylinder.
^
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
^
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
^
Remove and discard the ignition switch lock cylinder and drill shavings from the steering column.
5. Remove the bearing retainer.
6. Remove the bearing and the gear.
^
Thoroughly clean all drill shavings from the steering column and inspect it for damage.
Installation
The side air bag sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary batteries
and power supplies (if equipped).
