F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
4. To decrease caster and camber, use the following steps.
1. To decrease caster, move the front of the upper control arm inboard and move the rear of the upper control arm outboard.
2. To decrease camber, move the upper control arm inboard equally.
5. NOTE: Each increment of the notches on the frame pocket represents 0.4 degree.
Set the caster and camber to specifications.
^
If a caster increase of 1.2 degrees is required, move the front of the upper control arm outboard by 3 notches and move the rear of the upper
control arm inboard by 3 notches.
6. Tighten the nuts.
