F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
Selector Shaft: Service and Repair
4R70W
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. NOTE: Mark the driveshaft flange and rear axle companion flange for correct alignment during installation.
On 4x4 vehicles, remove the front driveshaft.
1
Remove the eight front driveshaft bolts (four each end).
2
Remove the front driveshaft.
4. Drain the transmission fluid and remove the fluid pan and filter.
5. Disconnect digital TR sensor electrical connector.
6. Disconnect the transmission shift linkage.