F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
1. Press the dust slinger on the coupling shaft.
2. NOTE: Press the bearing on the coupling shaft with the turned-in lip toward the dust slinger.
NOTE: The driveshaft center bearing bracket must be installed with the deep flange rearward.
Install the driveshaft center bearing support.
1
Install the rubber insulator in the driveshaft center bearing bracket.
2
Using a suitable press, install the driveshaft center bearing support assembly onto the coupling shaft.
3. Install the driveshaft center bearing retainer.
4. Slide the small opening end of the driveshaft slip-yoke boot on the splined stub shaft as far as it will travel.
5. Install the driveshaft slip-yoke boot clamp, and use Keystone Clamp Pliers to crimp the driveshaft slip-yoke boot clamp.
