F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
1. Slide the small opening end of the driveshaft slip yoke boot on the splined stub shaft as far as it will travel.
2. Install the driveshaft slip yoke boot clamp and use Keystone Clamp Pliers to crimp the driveshaft slip yoke boot clamp.
3. Install the driveshaft slip yoke.
1
Lubricate the stub shaft splines, and pull the driveshaft slip yoke boot towards the driveshaft.
-
Use Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B.
2
Fill the driveshaft slip yoke boot with approximately 10 grams of lubricant.
-
Use Premium Long-Life Grease XG-1-C or -K or equivalent meeting Ford specification ESA-M1C75-B.
3
Position the large driveshaft slip yoke boot clamp.
4
Align the blind splines, and install the driveshaft slip yoke.
4. Install the large driveshaft slip yoke boot clamp.
1
Remove any excess grease from the driveshaft slip yoke boot and driveshaft slip yoke surfaces.
2
Position the driveshaft slip yoke boot over the driveshaft slip yoke boot groove.
3
Position the driveshaft slip yoke to specification from the driveshaft weld to the U-joint centerline.
4
Bleed air from the driveshaft slip yoke boot.
5
Use Keystone Clamp Pliers to crimp the large driveshaft slip yoke boot clamp.
