F 150 2WD Pickup V8-5.4L SOHC VIN 3 (1999)
17. Trim the remaining urethane on the pinch weld to within specification.
^
The old urethane surface should be smooth and free of cuts and contamination.
INSTALLATION
CAUTION: After replacing the urethane installed glass, the vehicle should not be driven until the urethane has cured. The curing times at
temperatures above 13°C (55°F) and relative humidity above 50% is 12-24 hours (decreasing at higher temperatures and lower humidities).
Inadequate curing of the urethane may adversely affect the strength of the urethane sealant bond.
1. Check the pinch weld for damaged sheet metal, raised sheet metal at the spot welds, rust or foreign material that could cause glass damage.
2. Use a wool applicator to apply Urethane Metal Primer or equivalent meeting Ford specification WSB-M2G234-C to any exposed metal on the
pinch weld.
3. Apply (A) 8 mm foam butyl (part of EOAZ-19562-A) or equivalent meeting Ford specification WSB-M2G234-C to the (B) pinch weld.
4. Remove excess urethane from the windshield glass.
5. Clean the inside of the glass surface with an alcohol-free cleaner.
6. Apply Urethane Glass Prep (part of EOAZ-19562-A) or equivalent meeting Ford specification WSB-M2G234-C twice around the glass surface to
be urethaned.
NOTE:
^
Apply with deliberate strokes, making sure not to overlap the applied area.
^
Wipe off the Urethane Glass Prep immediately after application because it flash dries.
7. Cut the urethane applicator tip to specification.
8. Apply a urethane bead to the pinch weld just outside the foam butyl dam.
9. Install the inside rear view mirror.
