F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
1. CAUTION:
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute
cleanliness is observed when working with these components. Always install blanking plugs to any open orifices or tubes.
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube.
-
Make sure the quick release fitting clicks into place when installing the tube. To make sure that the quick release fitting is fully seated,
pull on the tube.
NOTE:
-
If the fuel tube retainer clip is broken or damaged, install a new clip using a suitable fuel line disconnect tool to separate the retaining clip legs.
Once the retainer legs have been separated, lift the clip out of the connector housing, lifting from the stamped side of the connector body.
-
Apply clean engine oil to the end of the tube before connecting the fitting.
Connect the quick release fitting.
2. For 4.6L late build vehicles, secure the EVAP fuel tube to the EVAP fuel tube bracket using a suitable tie strap.
