F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
Item 1: Electrical Connector Removal Note
1. If equipped, disconnect the backrest heated seat element electrical connector and release any wire harness retainers attached to the seat cushion
pan.
2. If equipped, disconnect the power seat motor electrical connector and release any wire harness retainers attached to the seat cushion pan.
3. NOTE: The safety belt buckle pretensioner electrical connector was disconnected in the deactivation procedure.
Disconnect the safety belt buckle switch electrical connector. If attached, release the safety belt buckle switch and safety belt buckle pretensioner
wire harnesses from the seat track.
Item 2: Belt Tension Sensor Electrical Connector (Vehicles With Seat Integrated Restraints Only) Removal Note
1. NOTE: Vehicles without seat integrated restraints (SIR) will have the belt tension sensor (BTS) connector at the B-pillar and will not have to be
disconnected for this procedure.
Disconnect the connector, release the J-clip and route out the wire harness.
Item 4: Seat Cushion Assembly Removal Note
1. If equipped with lumbar, release the J-clip and route out the lumbar cable.
2. NOTE: Disconnect and release any remaining electrical connectors and pin-type retainers necessary to remove the seat cushion pan.
Remove the seat cushion and pan assembly.
-
To aid in removal, recline the seat.
-
Remove the safety belt buckle from the seat cushion strap.
Item 5: Seat Cushion Trim Cover Removal Note
