ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Impact Sensor|Removal and Installation|Page 2612 > < Customer Safety Information|Page 2609
Page 1
background image

Impact Sensor: Service and Repair
Removal and Installation

FRONT IMPACT SEVERITY SENSOR

Diagnostic Tool, Restraint System

SPECIAL TOOL(S)

REMOVAL

WARNING:

-

Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.

-

Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the
sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.

-

The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could
result in injury and possible violation of vehicle safety standards.

NOTE:

-

The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

-

Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.

1. WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing

or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.

The front impact severity sensor is located on the hood latch support bracket.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

2. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the

supplemental restraint system (SRS) deactivation/reactivation procedure.  Refer to Air Bag(s) Arming and Disarming.

Deactivate the supplemental restraint system (SRS).  Refer to Air Bag(s) Arming and Disarming.

Impact Sensor|Removal and Installation|Page 2612 > < Customer Safety Information|Page 2609