F 150 2WD Pickup V8-5.4L SOHC VIN 5 (2004)
2.
If feathering is present, check the extent of the feathering by using a depth caliper to measure the difference between the highest and the lowest
point on each lug A-B-C (Figure 2). Do this in five (5) locations around the tire, then refer to one of the following procedures based on build date.
VEHICLES BUILT ON OR BEFORE MARCH 31, 2004:
1.
If the average difference in tread depth between leading and trailing edge is 0.08" (2 mm) or more, replace front tires and the upper control arms.
Inspect rear tires for abnormal wear, replace if tread depth is less than 0.16" (4 mm).
2.
If the average difference in tread depth between leading and trailing edge is less then 0.08" (2 mm), rotate the tires front to back. Tire replacement
is not required.
3.
Ensure that the camber and caster readings are within specification and set the front total toe to 0.20 +/- 0.05 degrees (nominal).
VEHICLES BUILT ON OR AFTER APRIL 1, 2004:
NOTE
THESE VEHICLES DO NOT REQUIRE UPPER CONTROL ARM REPLACEMENT, THE LATEST PART IS ALREADY INSTALLED.
1.
If the average difference in tread depth between leading and trailing edge is 0.08" (2 mm) or more, replace front tires. Inspect the rear tires for
abnormal wear, replace if tread depth is less than 0.16" (4 mm).
2.
If the average difference in tread depth between leading and trailing edge is less then 0.08" (2 mm), rotate the tires front to back. Tire replacement
is not required.
3.
Ensure that the camber and caster readings are within specification and set the front total toe to 0.20 +/- 0.05 degrees (nominal).
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
052606A
2004 F150: Inspect Tires,
1.9 Hrs.
Rotate Tires Front To
Back, Check And Adjust
Alignment
052606B
2004 F150 Built On Or
3.2 Hrs.
Before 3-31-2004: Inspect
Tires, Replace/Balance
The Front Tires And Front
Upper Control Arms,
Check And Adjust
Alignment
