F 150 4WD V8-4.6L VIN 8 (2010)
Memory Positioning Module: Service and Repair
Driver Seat Module (DSM)
Removal and Installation
NOTICE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to a scan tool. This information must be
downloaded into the new Driver Seat Module (DSM) after installation. For additional information, refer to Information Bus.
1. Remove the driver seat. For additional information, refer to Seats.
2. Remove the 2 screws.
-
To install, tighten to 7 Nm (62 lb-in).
3. Disconnect the electrical connectors and remove the DSM.
4. NOTE: Once the module is installed it is necessary to download the module configuration information from the scan tool into the new DSM. For
additional information, refer to Information Bus.
To install, reverse the removal procedure.
