F 150 4WD V8-4.6L VIN 8 (2010)
Removal and Installation
1. NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation
(PMI) in Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming
and Relearning
2. Remove the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
3. Disconnect the audio DSP module electrical connectors.
4. Remove the 3 bolts and the audio DSP module.
5. To install, reverse the removal procedure.
-
Download the configuration information to the audio DSP module. For additional information, refer to PMI in Information Bus. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
Audio Control Module (ACM)
Audio Control Module (ACM)
Base AM/FM
