F 150 4WD V8-4.6L VIN 8 (2010)
Auxiliary Step / Running Board Motor: Service and Repair
Power Running Board (PRB) Motor
Removal and Installation
NOTE: The Power Running Board (PRB) motor and brackets are serviced as an assembly.
1. Remove the PRB step. For additional information, refer to Power Running Board (PRB) Step See: Service and Repair/Power Running Board
(PRB) Step.
2. Disconnect the PRB electrical connector.
NOTICE: The following steps require an assistant. Failure to follow this instruction may result in damage to the vehicle.
3. Remove the PRB motor and bracket assembly front bracket upper bolts.
-
To install, tighten to 22 Nm (16 lb-ft).
4. Remove the PRB motor and bracket assembly front bracket lower bolts.
-
To install, tighten to 22 Nm (16 lb-ft).
5. Remove the PRB motor and bracket assembly rear bracket upper bolts.
-
To install, tighten to 22 Nm (16 lb-ft).
6. Remove the PRB motor and bracket assembly rear bracket lower bolts.
-
To install, tighten to 22 Nm (16 lb-ft).
7. Remove the PRB motor and bracket assembly.
8. To install, reverse the removal procedure.
