F 150 4WD V8-4.6L VIN 8 (2010)
Rear Door Panel: Service and Repair
Door Trim Panel - Rear, SuperCab
Door Trim Panel - Rear, SuperCab
NOTE: LH side shown, RH side similar.
Removal and Installation
1. Remove the inside door handle cover.
2. Remove the 2 inside door handle bolts.
3. Pull out the inside door handle and position the handle aside.
4. If equipped, remove the window control switch. For additional information, refer to Windows and Glass.
5. Remove the rear window rear garnish moulding.
-
Pull outward to release the garnish moulding clips from the door.
6. Remove the safety belt D-ring.
-
Remove the safety belt D-ring cover.
-
Remove the safety belt D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
7. Remove the rear door front garnish moulding.