F 150 4WD V8-4.6L VIN 8 (2010)
Steering Angle Sensor: Service and Repair
Steering Wheel Rotation Sensor
Removal and Installation
1. Disconnect the steering wheel rotation sensor electrical connector.
2. Remove the 2 bolts and the steering wheel rotation sensor.
-
To install, tighten to 3 Nm (27 lb-in).
3. To install, reverse the removal procedure.
4. NOTE: If the sensor is not calibrated after installation, a DTC will be set in the ABS module.
Calibrate the sensor in the following sequence:
1. Start the engine.
2. Rotate the steering wheel from lock to lock a minimum of 2 times.