F 150 4WD V8-4.6L VIN 8 (2010)
9. Install the CMP sensor and the bolt.
-
Tighten to 10 Nm (89 lb-in).
10. Connect the CMP electrical connector.
11. NOTICE: Only use hand tools to install the camshaft phaser and sprocket assembly or damage may occur to the camshaft or camshaft
phaser and sprocket.
NOTICE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
Tighten the new camshaft phaser and sprocket bolt in 2 stages:
-
Stage 1: Tighten to 40 Nm (30 lb-ft).
-
Stage 2: Tighten an additional 90 degrees.
12. Install the RH valve cover. For additional information, refer to Valve Cover - RH See: Cylinder Head Assembly/Valve Cover/Service and
Repair/Valve Cover - RH.
Camshaft Phaser and Sprocket - LH
Camshaft Phaser and Sprocket - LH
