F 150 4WD V8-4.6L VIN 8 (2010)
-
Tighten to 10 Nm (89 lb-in).
6. Install the starter wiring harness bolt.
-
Tighten to 10 Nm (89 lb-in).
7. Install the transmission fluid cooling tubes bracket bolt.
-
Tighten to 48 Nm (35 lb-ft).
4WD vehicles
8. NOTICE: Use care when positioning the front axle housing, or the vacuum lines to the axle solenoid may become disconnected or
damaged.
Raise the front axle into position.
9. Install the lower front axle housing mounting bushing bolt.
-
Tighten to 90 Nm (66 lb-ft).
10. Install the front axle housing mounting bushing bolt.
-
Tighten to 90 Nm (66 lb-ft).
